35.292.972�.AW1260.qxd 06/05/2005 17:45 P?gina 9
6. Start the programme8. Interrupting a programme
Before starting up the machine check that:Depress the Start/Pause button to interrupt a programme
the appliance is plugged inwhich is running, the corresponding light starts to flash.
the water supply tap is turned onDepress the button again to restart the programme.
the drain hose is correctly and securely positioned
9.Cancelling a programme
the door and the detergent dispenser drawer are
closed.Turn the selector dial to O to cancel a programme which
is running. Now you can select a new programme.
To start the selected programme, press the Start/Pause
button; the corresponding light stops flashing.
10. Opening the door after the
The "Wash" light illuminates.
programme has started
The machine starts operating.
First set the machine to PAUSE by pressing the
Start/Pause button.
If the Odoor� light flashes and after 2 minutes goes off,
the door can be opened.
If the Odoor� light doesnOt flash, this means that the
machine is already heating, that the water level is above
the bottom edge of the door or that the drum is turning.
In this case the door can not be opened.
If you cannot open the door but you need to open it you
have to switch the machine off by turning the selector dial
7. Altering an option or ato OO�. After about 2 minutes the door can be opened
running programme(pay attention to the water level and temperature!).
It is possible to change any option before the
programme carries it out.
11. At the end of the programme
Before you make any change, you must pause the
washing machine by pressing the Start/Pause button.The machine stops automatically.
Changing a running programme is possible only byIf the RINSE HOLD option has been selected, the
Ostart pause� light goes off, selected, the phase lights
resetting it. Turn the programme selector dial to OO�
Oend� and Odoor� illuminate, and the door is blocked to
and then to the new programme position. The washing
water in the tub will not emptied out .indicate that the water must be emptied out before
opening the door.
Start the new programme by depressing the
To do this first turn the programme selector dial to OO�
Ostart pause� button.
and then to drain programme 14 or spin programme 15
Reduce the spin speed if needed, by using the relevant
button
Release of the lock is also indicated by the coming on of
the OEnd� light.
Turn the programme selector dial to OO� to switch the
machine off. Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out another wash, close the
water tap. Leave the door open to prevent the formation
of mildew and unpleasant smells.
9 |
ACEC
